EverFocus ED Series Specifikace

Procházejte online nebo si stáhněte Specifikace pro Bezpečnostní kamery EverFocus ED Series. EverFocus ED Series Specifications Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 12
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
EVERFOCUS
1/3” Color Rugged Dome Camera
Operation Instructions
Model No.
EHD300N
Please read this manual first for correct installation and operation. This manual should be retained
for future reference. The information in this manual was current when published. The
manufacturer reserves the right to revise and improve its products. All specifications are therefore
subject to change without notice.
PRECAUTIONS
1. Do not install the camera near electric or magnetic fields.
Install the camera away from TV, radio transmitter, magnet, electric motor, transformer,
audio speakers since the magnetic fields generate from above devices will distort the video
images.
2. Never disassemble the camera nor put impurities in it.
Disassembly or impurities may result in trouble or fire.
3. Never face the camera toward the sun.
Direct sunlight or severe ray may cause fatal damage to sensor and internal circuit.
4. Keep the power cord away from water and liquid.
Touching the wet power cord may result in electric shock.
5. Never install the camera in areas exposed to water, oil or gas.
Water, oil or gas may result in failure, electric shock or fire.
Zobrazit stránku 0
1 2 3 4 5 6 ... 11 12

Shrnutí obsahu

Strany 1 - EVERFOCUS

EVERFOCUS 1/3” Color Rugged Dome Camera Operation Instructions Model No. EHD300N Please read this manual first for correct installation and op

Strany 2 - FEATURES

9SPECIFICATIONS Pickup Device 1/3'' SONY Super HAD CCD Video Format NTSC or PAL Scanning System NTSC: 525 TV lines, 60 fields/sec. PAL:

Strany 3 - INSTALLATION

10 CONTENT LIST Standard Accessories 1. Camera Unit 2. Operation Instruction (this document) 3. Accessory Pack 4. Waterproof Connector 5. Power

Strany 4

11EverFocus Electronics Corp. Head Office: 12F, No.79 Sec. 1 Shin-Tai Wu Road, Hsi-Chih, Taipei, Taiwan TEL: +886-2-26982334 FAX: +886-2-26982380 ww

Strany 5

16. Cleaning Do not touch the surface of sensor by hand directly. Use a soft cloth to remove the dirt from the camera body. Use lens tissue or a cott

Strany 6 - V. Phase A d j ustment VR

2INSTALLATION 1. Loosen the 4 fix screws on the housing cover by using the attached wrench (Figure 1). Please pay attention not to damage the lens.

Strany 7

33. Mounting the base. Attach the base to the wall or ceiling, fix the base by the 4 setscrews attached in the accessory pack. Please make s

Strany 8 - DIP SWITCH FUNCTION

4 Caution: To prevent moisture leaking into the housing, apply an appropriate gasket or sealant around the conduit connection. 4. Wire Connec

Strany 9

5 Connect the power supply cable (12VDC/24VAC), video output and alarm output to the proper connectors shown as Figure 5. The V. Phase adju

Strany 10 - SPECIFICATIONS

6 Figure 6 Lens fixing Screws 140° 360° 60°

Strany 11 - CONTENT LIST

7DIP SWITCH FUNCTION ¾ BLC (Back Light Compensation) When BLC is turned on, the AGC, FL and IRIS operating point is determined by averaging over the

Strany 12 - EverFocus Electronics Corp

8SIMPLE INSTRUCTIONS FOR THE DESICCANT PACK Due to the camera lens blurred from the humidity inside the camera. The desiccant pack absorbs the humid

Komentáře k této Příručce

Žádné komentáře