EverFocus EHN Series Instalační příručka

Procházejte online nebo si stáhněte Instalační příručka pro Bezpečnostní kamery EverFocus EHN Series. EverFocus EHN Series Installation guide Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 13
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
EZN Plus Series
Outdoor IR Bullet IP Camera
Quick Installation Guide
Copyright © EverFocus Electronics Corp,
Release Date: October, 2012
Zobrazit stránku 0
1 2 3 4 5 6 ... 12 13

Shrnutí obsahu

Strany 1 - EZN Plus Series

EZN Plus Series Outdoor IR Bullet IP Camera Quic

Strany 2 - 1. Overview

EZN Plus Series 9 5. Network Connections You can use one of the methods below to connect the camera to the network. Router or LAN

Strany 3 - 2. 4-Pin Data Cable

EZN Plus Series 10 Direct High-Speed Connection In a Direct High-Speed Connection, the camera connects directly to a modem without

Strany 4 - 3. Installation

EZN Plus Series 11 6. Upgrading Firmware You can upgrade camera’s firmware using the IP Utility software included in the software C

Strany 5 - Tilt Screw

EverFocus Electronics Corp. EverFocus Taiwan: 12F, No.79, Sec. 1, Shin-Tai Wu R

Strany 6 - Fix Screw

EZN Plus Series 1 1. Overview The EZN Plus Series is a bullet type IP camera designed for

Strany 7

EZN Plus Series 2 System Requirements Before installing, please check that your computer meets the following system requirements. •

Strany 8 - 4. Accessing the Camera

EZN Plus Series 3 3. Installation This installation guide provides the basic instructions on installing an EZN Plus bullet IP camer

Strany 9

EZN Plus Series 4 b. If you want to wire the cables through the wall, feed the cables through the wall and then screw the c

Strany 10 - 5. Network Connections

EZN Plus Series 5 3.2 Inserting a Micro SD Card You can optionally insert a micro SD card to the card slot on the camera module fo

Strany 11 - Assign IP Address

EZN Plus Series 6 3.3 Adjusting Camera Focus / Zoom After wiring the cables, you can adjust the camera focus and zoom for better i

Strany 12 - 6. Upgrading Firmware

EZN Plus Series 7 4. Accessing the Camera You have to assign an IP address for your camera to be accessible. To assign an IP addres

Strany 13 - EverFocus Electronics Corp

EZN Plus Series 8 You can also change the other settings by double-clicking the values. After configuring the values, click Save Co

Komentáře k této Příručce

Žádné komentáře