EverFocus EFC306 Uživatelský manuál Strana 57

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 160
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 56
NAV IP Access controller
48
Press toentertothealarminputsetting,thesystemwillfirstpromptuserstoselectanalarminput,
likethebelowwindow.Total10alarminputs(09)availableinNAVController.
5.6.4.13 Alarm Input Mode
Attheabovewindow,press toentertothesettingforalarminput#1.The1
st
submenuisthealarm
inputmodesubmenu,useandtoswitchtoothersubmenus.
Three alarm input modes are available: N.O., N.C, and Invalid. Press to toggle among the three
modes.
N.O.modeindicatesthenormal status (no alarm input signal) of circuit is disconnected. It will
be
alarmedifthealarminputisactiveandthecircuitwillbeclosure.
N.C.modeistheinversedcaseofN.O.Itmeansthenormalstatusofcircuitisclosure.Itwillbe
alarmedifthealarminputisactiveandthecircuitwillbedisconnected.
Invalidinputindicatestherelatedalarminputisdisabled.
5.6.4.14 Alarm Output Mode
Atthefollowingwindow,presstoconfigurethealarmoutputmode
Therearetwoalarmoutputmodes:latchedmodeandtransparentmode.
Presstotogglebetweenthetwomodes.
Transparentmodeindicatesthealarmoutputwillpresentaslongasthealarminputisvalid,and
alarm output will
disappear when the alarm input is invalid. The duration of alarm output is
purely controlled by the duration of valid alarm input, not related with the timeout
configuration.
Latchedmodeindicates that alarm output can only be triggered by the valid alarminputafter
the arm delay duration. And
the alarm output will be last for the specified alarm timeout
duration.
Alarm Output Mode
Transparent
Alarm Output Mode
Latched
Alarm Output Mode
Alarm Input Mode
Invalid
Alarm Input Mode
Normally Close Mode
Alarm Input Mode
Normally Open mode
Alarm Input Mode
Alarm Input ---1
Setting
Zobrazit stránku 56
1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 159 160

Komentáře k této Příručce

Žádné komentáře