EverFocus EFC301 Uživatelský manuál stáhnout pdf (Strana 21)

NAV Series TCP/IP Standalone Network Access Controller

3 StartingUptheController

3.1 Connecting to Power

YoucanpowertheEFC301controllerthroughaspecificPoEnetworkswitchusinganetwork

cable,orbyconnectingtheextensionwireoftheterminalblockontherearpanel.The No.3

andNo.5arethepositivepoleandnegativepoleofthecontroller,respectively.



Figure3‐1



Note:

1. ThevoltagerangeofpowersourceforEFC301controllerisDC11‐16V.Themaximum

currentofthecontrolleris600mA.

2. Thedistancefromthepowersupplytothecontrollershouldbeminimal.Inaddition,

theelectromagneticlockandalarmequipmentmustbepoweredseparatelyfromthe

controller.Poweringthe electromagneticlockandalarmequipmentatthesametimeis

prohibited.



3.2 Restoring the Controller

Torestorethecontrollertothefactorydefaultsettings,pleaseenterthemanagementmenu

of the controller and select “Factory Default Restore” in the management menu of the

system.



3.3 Before First Use

Beforefirstuse,pleasefollowtheinstructionsbelow:

外接端口

RJ45

Chapter

External port

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 119 120

Žádné komentáře

EverFocus EFC301 Uživatelský manuál Strana 21