EverFocus ECOR 4 Manuál s instrukcemi stáhnout pdf (Strana 82)

 To access the DVR from a computer simply open Internet Explorer and in the address bar type:

http:// (IP address of the DVR)

 Note: The DVR’s IP address will only work at the location of the DVR. To connect from a

different location over the Internet, see below.

To set DVR for Internet Connection through router

 The next step is to open ports within your router. Log into the router using a PC and open the

following ports.

o ECOR Ports to open: 80, 1600

o If your Internet service provider blocks port 80, you can change it to a different port in the

DVR’s Network Menu Setup.

o If you are using a Linksys or D-Link router, see Chapter 9 for basic support on setting up

ports. For any other router, you will need to contact the manufacturer for support.

 To access the DVR from a computer simply open Internet Explorer and in the address bar type:

http:// (the IP address given by your internet service provider)

 Note: If you changed to a different port other than 80, you will need to include this at the

end of the IP address

Example: http://70.20.70.20:8100

 If you have a Dynamic IP address and have opened the ports, go to the next chapter to setup

DDNS.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 106 107

Žádné komentáře

EverFocus ECOR 4 Manuál s instrukcemi Strana 82