EverFocus EBC890 Uživatelský manuál stáhnout pdf (Strana 58)

5050

Software Setup

Please Note: This is a brief instruction on EverAccess Flex Series Software for more

detailed instruction guide please refer to the EverAccess Flex Series Software Manual.

The next step after hardware installation is to configure the whole access control system. Flex

series controller has the ability to allow users configure the basic setting through the keypad on

the controller. But for the detailed, complicated settings, we recommend to use the

management software. To configure the system in software, several major steps that you need

to follow are shown as below:

1. Install the software in the control computer

2. Setup the user accounts who will use the software

3. Configure the controller and all other hardware settings

4. Configure the holidays, access group and the door control schedule

5. Enroll the cards and set the cardholders’ properties

Install the Software in the Control Computer

Just like installing any other software in the computer, inserts the software installation CD into

the CDROM, and run the setup program. Choose a special installation folder if needed,

otherwise just follow the setup wizard and choose the default selection.

To run the software, you need the administrator privilege and the basic computer requirement

is as follows:

1. Pentium 3 CPU

2. Windows 2K, XP

3. 100M bytes free space in hard drive

4. 128M memory

For the details of the software installation and the minimum computer requirement, please

refer to the software manual.

Chapter

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 64

Žádné komentáře

EverFocus EBC890 Uživatelský manuál Strana 58